Starting The Dishwasher - Bosch SHE44C Guide D'entretien Et D'utilisation

Operating the Dishwasher

Starting the Dishwasher

To start the dishwasher, follow the instructions
in Figures 19 and 20 depending the control
location.
Exposed Front Controls
1) Close the door
2) Turn on
Hidden Top Controls
1) Open the door
2) Turn on
Interrupting a Cycle
NOTE: Should you need to interrupt a cycle (to
add or remove an item, to add detergent, etc.), it
is best to do so within the fi rst 30 minutes of the
cycle.
WARNING
You could be seriously scalded if you allow
hot water to splash out of the dishwasher.
OPEN THE DOOR CAREFULLY during any
wash or rinse cycle. Do not fully open the
door until water noises have stopped.
Exposed Front Controls (See Figure 19)
1. Press the On/Off button to turn the unit off.
2. Wait at least ten seconds or until the water
noises stop before opening the dishwasher
door.
3. To resume the cycle, close the dishwasher
door and then press the On/Off button.
12
4) The unit will
then start
3) Select a cycle
Figure 19
4) Close the
door to start
3) Select a cycle
Figure 20
(continued)
Hidden Top Controls (See Figure 20)
1. Open the dishwasher door just far enough to
expose the control panel.
2. Press the On/Off button to turn the unit off.
3. Wait at least ten seconds or until the water
noises stop before opening the dishwasher
door.
4. To resume the cycle, press the On/Off button
and close the dishwasher door.
Canceling or Changing a Cycle
(All Models Except SHE53L0)
To cancel or change a cycle, press and hold for
three seconds the two buttons labeled "Cancel
Drain" as shown in Figure 21.
With the door closed, wait until the dishwasher
completes the cycle (approximately 1 minute).
Then press the ON/OFF button.
You may now begin a new cycle.
(For Model SHE53L0)
Turn the cycle selection knob to the "Reset 3
sec." position.
Wait approximately one minute and then press
the ON/OFF button.
You may now begin a new cycle.
Figure 21
Cancel Drain