Retrieving Dab Info; Setting The Drc; Bluetooth Playback; Pairing And Deleting Bluetooth Devices - Sonoro SO-110 Mode D'emploi

11.2.4

Retrieving DAB info

In DAB mode, you can call up information on the sta-
tion, programme, etc. The information is displayed in
the following order:
n Station name (starting point)
n Broadcaster
n DLS ("Dynamic Label Service", programme-related
information, such as artist, track, etc.)
n Programme type (e. g. sport)
n Station frequency
n Signal quality
1. Press the [DAB] button on the remote control in
DAB mode.
ð The display shows the information in the
order listed above.
2. Press the [DAB] button on the remote control
again.
ð The display shows the next information.
3. Proceed accordingly to retrieve the remaining
DAB information.
11.2.5

Setting the DRC

The DRC (Dynamic Range Compression) setting
reduces the difference in volume between quieter
and louder passages.
3 different settings are available for the DRC function:
n DRC High
n DRC Low
n DRC Off
Prerequisite:
The device is in DAB mode.
1. Press the [MENU] button.
ð The display shows the text [Full Scan].
Fig. 39: Setting the DRC
2. Turn the click wheel until the display shows
[DRC Setting] (Fig. 39).
3. Press the click wheel or the [OK] button on the
remote control to confirm the selection.
4. Turn the click wheel to choose the desired set-
ting.
60
5. Press the click wheel to confirm the setting.
12

Bluetooth playback

Mobile phones and other Bluetooth-enabled devices
can be paired with the sonoroRADIO via Bluetooth.
i
Use the manual of your mobile phone or Bluetooth
device for help.
Fig. 40: Setting the Bluetooth mode
1. Switch on the sonoroRADIO.
2. Press the [MODE] button on the front of the
device until the display shows the [Bluetooth]
symbol. You can also press the [Bluetooth]
button on the remote control.
ð The Bluetooth mode is now active (Fig. 40).
3. Pair your mobile phone or Bluetooth device to
the sonoroRADIO via Bluetooth.
i
Enter code '0000' .
i
The radio can store up to 8 Bluetooth devices, and
pairs with previously configured devices automati‐
cally if Bluetooth is enabled.
Pairing and deleting Bluetooth
12.1
devices
Pairing Bluetooth devices
Fig. 41: Searching for Bluetooth
1. Activate Bluetooth mode.
ð The display shows [Searching], and the
[Bluetooth] symbol flashes (Fig. 41).
© 2013