Personnel Qualification; Obligations; Organisational Measures; General Risks When Using The Product - HYDAC ELECTRONIC HAT 1400 CAN Notice D'utilisation

HAT 1400 CANopen

2.4 Personnel qualification; obligations

 All work on the measuring system must be carried out by qualified personnel only.
Qualified personnel includes persons, who, through their training, experience and
instruction, as well as their knowledge of the relevant standards, provisions, accident
prevention regulations and operating conditions, were authorized by the persons
responsible for the system to carry out the required work and are able to recognize and
avoid potential hazards.
 The definition of "Qualified Personnel" also includes an understanding of the standards
VDE 0105-100 and IEC 364 (source: e.g. Beuth Verlag GmbH, VDE-Verlag GmbH).
 Define clear rules of responsibilities for the assembly, installation, start-up and
operation. It is obligatory to provide supervision for trainee personnel!

2.5 Organisational measures

 The user manual must always be kept accessible at the place of use of the measuring
system.
 In addition to the user manual, generally applicable legal and other binding accident
prevention and environmental protection regulations must be paid attention to and must
be mediated.
 The respective applicable national, local and system-specific provisions and
requirements must be paid attention to and mediated.
 It is mandatory for the operator to inform personnel on special operating features and
requirements.
 The personnel instructed to work with the measuring system must have read and
understood the user manual, especially the chapter "Basic safety instructions" prior to
commencing work.
 The nameplates and any prohibition or instruction symbols applied on the measuring
system must always be maintained in a legible state.
 Repairs may only be undertaken by the manufacturer or a facility or person authorized
by the manufacturer.

2.6 General risks when using the product

The product, hereinafter referred to as "the measuring system", is manufactured
according to state-of-the-art technology and accepted safety rules. Nevertheless,
improper use can pose a danger to life and limb of the user or third parties, or
lead to impairment of the measuring system or other property!
Only use the measuring system in a technically acceptable state, and only for its
designated use, taking safety and hazard aspects into consideration, and paying
attention to the user manual! Especially faults which could threaten safety should be
eliminated without delay!
Edition: 2021-02-18 HYDAC ELECTRONIC GMBH
7
E
Part No.: 669987