Safety Devices Adopted - Gentilin C 660/100 Manuel D'instructions

• SAFETY VALVE (10): a certified safety valve (set to 10.5 bar), installed to the pneumatic system, under the pressure
switch. It tackles over-pressure in the instance where, owing to anomalies, the pressure switch does not function. Safety
valve intervention ensures the operator switches off the appliance and requests the support of maintenance persons.
• PRESSURE SWITCh (2): an electro-pneumatic device (set to a minimum of 7 bar and a maximum of 10 bar) installed to
the pneumatic system. It serves to control the automatic start-up of the appliance when the operating pressure comes
down to 7 bar and the automatic close-down when the pressure reaches 10 bar.
• FIxED COOLING FAN PROTECTIVE NET (19): fixed protection made of plastic attached using screws fixed to the twin
cylinder pump system base. It serves to stop accidental contact with the cooling fan when in motion.
• TANk PRESSURE GAUGE (15): a measuring device installed to the appliance tank. It displays the compressed air pres-
sure inside the tank.
• OUTLET PRESSURE GAUGE (8): a measuring device installed to the appliance pneumatic system above the air outlet
spigot. It displays the outlet pressure, which can be adjusted using the relative pressure regulator (0÷10 bar) (7).
all SaFEtY DEViCES inStallED on tHE aPPlianCE MUSt
BE REGUlaRlY CHECKED to EnSURE tHEY aRE FUnCtion-
inG CoRRECtlY.
anY SaFEtY DEViCES WHiCH aRE not FUnCtioninG CoRRECtlY
oR WHiCH aRE DaMaGED MUSt BE iMMEDiatElY REPlaCED.
tHE HanDlinG, EXClUSion anD/oR REMoVal oF SaFEtY DE-
ViCES inStallED on tHE DEViCE iS StRiCtlY FoRBiDDEn.
REPlaCinG a SaFEtY DEViCE oR CoMPonEntS oF SaFEtY
DEViCES WitH UnoRiGinal REPlaCEMEnt PaRtS iS StRiCtlY
FoRBiDDEn.
2
10
7
15
8
Rev. 01 - 07/2014 - Instruction manual

19. SAFETY DEVICES ADOPTED

19
E480 - E660
Compressor Mod. C660/100 - E480/100 - E660/100
2
15
10
7
8
19
C660
13