Start Time - Vortice Reg Depuro Plus Notice D'emploi Et D'entretien

ENGLISH
READ ONLY RECORDS
Record 57: Current fan speed [read-only].
High Byte: The value that is sent is the speed value (0% to 100%) in 16-bit binary.
Low Byte: The value that is sent is the voltage value (0.0 to 10.0V) multiplied by 10 in 16-bit binary.
This voltage value corresponds to the analog output of the regulator for the fan speed (terminals 19 and 20).
Fan operation (voltage):
OFF 0.0V
ON
0% 0.0V
1% Minimum voltage (Record7)
...
100% Maximum voltage (Record 8) End of line resistance configuration
Fan operation
Record 58: Filter status (by timer) [read-only].
High byte: F7 filter.
0: Filter clean.
1: Dirty filter.
High byte: pre filter.
0: Filter clean.
1: Dirty filter.
Low byte: H14 filter.
0: Filter clean.
1: Dirty filter
Record 59: Current status PHOTOCATALYSIS-UVC module [read only].
0: Off (PHOTOCATALYSIS-UVC module deactivated - relay contact open).
1: On (PHOTOCATALYSIS-UVC module activated - relay contact closed).
Photocatalysis-Module ON
Record 59, Byte high=1
Photokatalysis-Module OFF
Record 59, Byte high=0
Time
Record 28 (Byte high)

Start Time

End Time
Record 19 (Byte high) Record 19 (Byte low)
Record 60: Firmware version [read-only].
The value that is sent is the value of the controller software version (XX.X) multiplied by 10 in 16-bit binary.
Note: When powering the regulator, or after a reset, it displays the firmware version on the display (v X.X).
44