Electric Connections; Instructions For Start-Up - Vortice VORT T Notice D'emploi Et D'entretien

ENGLISH
ELECTRIC CONNECTIONS
1 = POWER 230 Vac
2 = POWER 230 Vac
3 = Pr2 ... TEMPERATURE PROBE
4 = GND ... TEMPERATURE PROBE
4 = GND ... GROUND ANEMOMETER
5 = Pr1 ... IOUT 4/20 mA ANEMOMETER
6 = +12V ... +Vcc ANEMOMETER
7 = NO ... CONTACT NO ALARM
8 = C ... COMMON ALARM
9 = NC ... CONTATTO NC ALARM
18 = GND- ...-0 FAN SIGNAL OUTPUT
19 = +10V ... +10Vcc FAN SIGNAL OUTPUT
INSTRUCTIONS FOR START­UP
The unit switches to B mode when it is powered. (See a description of modes A and B below).
The panel is set to automatic mode upon first start­up.
At subsequent start­ups, the panel will be set to the mode last saved before the last shut­down.
Below is a description of the various features found on the unit. All parameters described initially
have factory set values.
Note: If the necessary probes are not present, the unit will operate continuously as a normal fan at
the initially set speed.
FAN SIGNAL OUTPUT 0-10V
7