Vortice THERMOLOGIKA DESIGN Notice D'emploi Et D'entretien page 8

ENGLISH
people are present.
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• Take particular care if the appliance is used in
unsupervised environments.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Regularly inspect the appliance for visible defects. If
any faults are found, do not operate the appliance;
contact Vortice** immediately.
• Never position the appliance directly under a power
socket.
• The appliance must be correctly connected to an
electrical supply that conforms to applicable
standards and is equipped with an efficient earth
connection. If in doubt, have a qualified electrician
perform a thorough check.
• The appliance must be installed by a professionally
qualified electrician only, and in compliance with the
instructions given in this booklet. Incorrect installation
and/or electrical connections can lead to injury to
persons or animals or other damage for which Vortice
cannot be held responsible.
• The electrical power supply/socket to which the
appliance is connected must be able to provide the
maximum electrical power required by the appliance.
• Switch off the appliance at the installation's main
switch before cleaning or maintaining it.
• Should the appliance be dropped or suffer a heavy
blow, have it checked by Vortice immediately.
• If the appliance does not function correctly or
develops a fault, contact Vortice** immediately.
Ensure that only genuine original Vortice spares are
used for any repairs.
• Switch off the appliance at the main switch: a) if the
appliance does not function correctly; b) before
cleaning the outside of the appliance; c) if the
appliance is not to be used for a long period of time.
• Never cover or block the radiating element grille.
• Keep the radiating element grille clean.
To avoid all risk of fire, never
•
install the appliance with the
radiating elements
pointing towards curtains, beds or
any other flammable materials.
Keep the appliance at least 1
metre from any other surface.
The appliance must be installed
•
by a professionally qualified
electrician.
The electrical system to which
•
the product is connected must
be in compliance with applicable
8
regulations.
An omnipolar switch with a
•
contact opening distance of 3
mm
provided
enabling
disconnection under overvoltage
category III conditions.
• Do not operate the appliance by means of
programmers, timers or other automatic switching
devices.
• The appliance's grille has been design to prevent
direct access to the radiating elements. Never
operate the appliance without the grille.
The
•
connected to the power supply
using cable resistant to high
temperatures, type H05SS-F.
near or
or higher should
for installation,
appliance
be
complete
must be