To Stop The Product - Husqvarna ST 324 Manuel D'utilisation

5. If the product has power steering, hold the left
steering trigger (D) to turn left. Hold the right steering
trigger to turn right.

To stop the product

1. Move the throttle control (A) to the STOP position.
A
2. Remove the ON/OFF key.
To use the throttle control
• Turn the throttle control (A) to change the amount of
fuel used. Always operate the engine at full throttle.
A
633 - 005 - 17.12.2019
To use the fuel switch
• Turn the fuel switch to open or close the fuel valve.
Operate the product with the fuel switch in the OPEN
position.
D
To use the choke control
• Turn the choke (A) to open or close the choke valve.
Use the choke to start a cold engine.
To adjust the skid plates
No adjustment is required for normal installation.
1. When the lock nut (B) is loose or the skid plate (A) is
not high enough from the ground, unlock the lock nut
(B) with a 13 mm open-ended wrench, to move the
skid plate up or down.
2. On flat surfaces, like asphalt roads, raise the skid
plates (A) 5-6 mm (0.2-0.25 in) off the ground. On
uneven surfaces, like gravel roads, make the
clearance between the ground and the product
larger with the skid plates to get the scraper bar
above the top of the gravel. Make sure that the
gravel and stones do not enter into the product. It
can cause personal injuries if objects are ejected at
high speed.
OFF
FUE
INSTR UCTIO NS
ON
A
LCO NTR OL
13