Connecting The Camera - Dometic GROUP WAECO PerfectView CAM604 Instructions De Montage Et De Service

PerfectView CAM604
➤ Drill a hole of Ø 16 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place a cable sleeve in all sharp edged ducts.
Fastening the camera
➤ Push the camera into the bracket (fig. i, page 8).
A
NOTICE!
Only use the screws supplied to mount the camera in the camera
holder. Longer screws will damage the camera.
➤ Secure the camera loosely with the four M4 x 6 screws in the two other
fixing holes (fig. i, page 8).
The camera is now centred.
➤ Align the camera so that the lens is at an angle of approx. 25° ± 5° to the
vertical axis of the vehicle (fig. k, page 9).
I
NOTE
Do not tighten the four M4 x 6 screws until you have aligned the
camera (see chapter "Checking the function and setting the cam-
era" on page 38).
To do this you must first install and connect a monitor.
8.3

Connecting the camera

I
NOTE
 Lay the camera cable so that, should you need to remove the
camera, you can access the plug connection between the
camera and the extension cable easily. This facilitates the dis-
assembly considerably.
 To minimise corrosion in the plug, apply a small amount of
grease, such as pin grease, in one of the plugs.
➤ Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the extension cable
(not included in scope of delivery, fig. l 1, page 9).
➤ Screw on the plug connection of the connecting cables to protect against
water penetration (fig. 0, page 5).
EN
Fitting the camera
37