Dometic GROUP WAECO PerfectView CAM604 Instructions De Montage Et De Service page 35

PerfectView CAM604
Observe the following installation instructions:
 To provide a suitable viewing angle, the camera must be attached at a
height of at least 2 m.
Ensure that you have a firm place from which to work when mounting the
camera.
 Make sure that the installation location of the camera is sufficiently firm
(e.g. to prevent the camera from being knocked down by branches that
may brush the roof of the vehicle).
 Mount the camera horizontally and in the middle of the rear of the vehicle
(fig. d, page 7).
 The most secure type of attachment is with screws fitted through the
body. Please observe the following instructions:
– There must be sufficient space behind the chosen installation location
to be able to carry out the mounting procedure.
– Suitable measures must be taken to prevent water penetrating through
any holes made (e.g. by using screws and sealant and/or spraying the
outer attachment parts with sealant).
– The location on the body where you wish to attach the camera must
be rigid enough to allow the camera to be tightly fastened.
 Check beforehand that there is sufficient space on the other side for the
drill head to come out (fig. 2, page 4).
 If you are not sure about the location you have chosen, ask your vehicle
manufacturer or dealer.
I
NOTE
We recommend greasing the threads of the bolts to prevent
corrosion.
To perform the installation, proceed as follows:
➤ Hold the camera holder at the chosen location and mark at least two
different points for the drill holes (fig. e, page 7).
➤ Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
EN
Fitting the camera
35