Dometic GROUP WAECO PerfectView CAM604 Instructions De Montage Et De Service page 29

PerfectView CAM604
Observe the following installation instructions:
 Secure the parts of the camera installed in the vehicle in such a way that
they cannot become loose under any circumstances (sudden braking,
accidents) and cause injuries to the occupants of the vehicle.
 Secure any parts of the system concealed by the bodywork in such a
manner that they cannot be come loose or damage other parts or cables,
or impair vehicle functions (steering, pedals, etc).
 To prevent damage when drilling, make sure there is sufficient space on
the other side for the drill head to come out (fig. 2, page 4).
 Deburr all drill holes and treat them with a rust-protection agent.
 Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only
be performed by qualified specialists.
Observe the following instructions when working with electrical parts:
 When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 8, page 3) or a voltmeter (fig. 1 9, page 3).
Test lamps with a bulb (fig. 1 12, page 3) consume voltages which are
too high and can damage the vehicle's electronic system.
 When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 3,
page 4).
 Insulate all connections.
 Secure the cables against mechanical wear by using cable binders or
insulating tape, for example on existing cables.
The camera is watertight. However, the seals on the camera cannot with-
stand a high-pressure cleaner (fig. 4, page 4). Therefore, you should
observe the following instructions when handling the camera:
 Do not open the camera, as this impairs the leak tightness and the func-
tion of the camera (fig. 5, page 4).
 Do not pull at the cables, as this impairs the tightness and the function of
the camera (fig. 6, page 4).
 The camera is not suitable for use under water (fig. 7, page 4)!
EN
Safety and installation instructions
29