Switching Off - Siemens DE04101M Mode D'emploi

The temperature of the water leaving the tap is dependent on the flow of water:
ΔT
50
[°C]
40
30
20
10
0
1,2 1,4 1,6 1,8 2,0 2,2 2,4 2,6 2,8 3,0 3,2 3,4 3,6 3,8 4,0 4,2
Operating instructions
Please read and observe the detailed safety
instructions at the start of these instructions!
Important: The appliance may never be exposed
to frost!
Risk of electric shock!
Switch off the mains voltage supply
immediately if a fault occurs (DE05101M,
DE06101M, DE06111M, DE08101M,
DE08111M) or disconnect the plug from
the mains supply (DE04101M, DE10104M).
Immediately shut off the cold water supply to
the appliance should it leak.
18
3,6 kW 4,5 kW
en
6,0 kW
Operation
The electronic continuous-flow heaters of this series
operate automatically.
Switching on
Open the tap fully. The electronic continuous-
flow heater switches on. The water is heated as
it flows through the appliance.
The over-sink appliances DE06111M and
DE08111M feature an automatic operation indi-
cator. The operation indicator lights yellow at half
power and red at full power, dependent on the
water flow rate.

Switching off

Close the tap, and the appliance will switch off.
Regulating water temperature
Open the tap fully, and the appliance switches on.
Now increase the temperature of the water by
reducing the flow of water.
Info: In winter, the temperature of the water supply
may be lower, so that the temperature of the water
leaving the tap will not be reached. Please proceed
as described under "Water connection".
7,2 kW
Q
[l/min]