Kemper MiniFil Mode D'emploi page 59

b) Replacement of the particle filter
Release the bolts (fig. 5, pos. 1).
Remove the cover now (fig.5, pos. 2).
Remove the dust filter and place it in the plastic bag supplied with the
replacement filters. Seal with cable tie.
Now insert the new particle filter into the MiniFil device. Make sure that the
foam seal indicated in Fig. 5 pos. 3.2 is oriented towards the inner side of the
device, see the figure.
Subsequently return the cover on the MiniFil device. Please remember that
individual rows of small exhaust slots must be oriented towards the lower side
of the MiniFil device.
After replacing the appropriate filter media perform the following steps:
Slide the mains plug in the socket again and switch on the device. The green
operating light on the button (fig. 3, pos. 1) should be lit to indicate a trouble-
free operation.
Dispose of the used filter in accordance with the official regulations. Request
the relevant waste codes for these purpose from your local waste processor.
Finally clean the maintenance premises, for example by industrial vacuum
cleaner of dust class "H".
- 60 –
Technical changes and errors reserved.
KEMPER MiniFil Instruction Manual - EN