Basic Configuration; Date And Time; Input Configuration - AKO CAMRegis 15740 Mode D'emploi

Installing the thermal paper roll
AKO-15742/15752/15782 only
-With the unit connected to the network, open the front cover
and push the release lever (1) back.
-Place the paper roll in the position shown on the image.
-Push the end of the paper through the bottom slot of the printer
until the latter starts to pull it. When the paper comes out of the top
slot, return the release lever to its initial position, the printer is ready
to print.
-Press the E key to feed the paper through.
-Press the D key for express printing.
To print data, the data logger has to have at least one entry recorded.
The required printing time will depend on the entry interval configuration (default is 15').
IMPORTANT: The printer paper is thermal and can only be printed on one side. Make sure you insert it
properly.
Start-up

Basic configuration

Enter the configuration menu pressing the SET key for 5 seconds.
Configuration changes are applied when you exit, the device will ask you if you are sure about the changes made.

Date and time

Set the current date and time using the P, O, N and Q keys, press SET to accept the changes.

Input configuration

Select the input type as required using the N and Q keys, press SET to accept the changes.
Repeat the action for each input used. If you do not use an input, configure it as disabled.
When you connect the power supply the first time (or in case of a power failure
and subsequent discharge of the battery), you must select a language from
among the available options.
Select the most adequate language using the N and Q keys, press SET to accept
the changes.
SET
SET
16
1
SET
SET
1575H031 Ed.04