ADURO DraftOptimizer Manuel D'installation Et D'utilisation page 25

Power supply:
Finally, put the plug from the power supply in the control box, and connect the power supply to a
switched-on socket outlet. Now, the Aduro DraftOptimizer is ready for use.
Important! The power supply should always be connected to constant current – also in the
summer period - and cannot be placed where there is a risk of water, splashes, moisture or
temperatures above 50 °C. The power supply must be placed so it's freely ventilated. If placed
outside, the power supply and the control box have to be in shade and in a waterproof IP 54
installation box.
Changing the engine cable:
If it becomes necessary to extend the black engine cable, it is recommended to replace the whole
cable so joints are avoided.
Tools: Cross-point screwdriver size 2 and a socket spanner size 7 mm.
1. Installation of top ring:
The top is dismantled by removing the two Philip screws
underneath the top ring on either side of the unit.
Philip screw
2. Dismantling of cooling unit:
The black engine cable is pulled loose from the cable
holder underneath, and the whole cooling unit is lightly
removed from the unit. IMPORTANT: Be very careful that
the impeller wings don't fold.
22
3. Dismantling of cooling
top:
The four lock nuts which
fasten the cooling top to
the cooling house are
dismounted and removed.
Now, the cooling top with
the cooling pipes can be
lightly removed.
Remember to let the black
cable slide along with it
when you remove the
cooling top.