Table des Matières
Publicité
EN
V CONVERTING THE BASSINET INTO THE SEAT
To convert the bassinet into the seat, you must first pull out the belts on both sides
of the shell (FIG. 21) and under the footrest. Connect the ends of the belts behind
the back, under the seat and the footrest (example Figure 22). Properly fastened
belts should look as shown in Figure 23 (seat angle control method described in
section VIII).
VI MOUNTING THE BAG, MOSQUITO NET AND RAIN COVER
MOOV includes a bag (M), mosquito net (N) and rain cover (O). Hang the bag on the
parent handle and secure with snaps (FIG. 24).
Place the mosquito net and secure with Velcros.
Place the rain cover on the buggy and secure with Velcros around the frame (FIG. 26).
VII MOUNTING THE BABY CAR SEAT
The supplied adapters (L) are compatible with the following car seats: Kinderkraft,
Maxi Cosi®, Cybex® and are suitable for models such as: Kinderkraft MINK, Cybex
Aton, Aton 2, Aton Q i Maxi Cosi Mico, Mico AP, Mico NXT, Mico Max 30, Citi, Cabrio,
and CabrioFix.
Slide the adapters into the slots in the frame until you hear the sound of the lock
(FIG. 27). The adapters should be slightly tilted to the parent. Put the seat in the
adapters and make sure it is properly secured. MOOV buggy with MINK car seat are
shown in Figure 28. To remove the adapters of the buggy frame, press the lock button
in each of the adapters (FIG. 29).
WARNING! The seat must be always placed on the frame back
to the direction of travel (the child should face the person
pushing the buggy).
VIII USE OF BRAKE
The buggy is equipped with a foot brake located on the rear axle. Press the brake
pedal down to activate it. The brake is released after the pedal is lifted up (FIG. 30).
IX BUGGY DISASSEMBLY
After removing the bassinet/seat or car seat (FIG. 29 & 40), press the frame folding
lock, then pull the levers on both sides and finally push the parent handle (FIG. 31).
A correctly folded frame must be secured with the side lock (FIG. 32). If necessary,
the front and rear wheels can be removed from the frame by pressing the buttons
marked in Figures 33 and 34.
30
Publicité
Table des Matières
