Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9
Configuration
9.1
To change values
To increase or decrease the displayed value, just press
to next parameter.
9.2
To change values
To enter or change the configuration parameters (see par. 10), the controller must
be in STOP-mode.
Press
1
Press for 5 s.
2
3
4
5
6
Display
0.000
Display visualizes
1st number on the left flashes.
Flashing digit changes.
P-0 1
Display
flashing.
Press this key to scroll through all
the parameters.
Increase or decrease the value.
End of configuration. The control-
ler is set as STOP-mode.
and the
Enter password
to skip to next number and then
to display the 1st parameter.
When the display reaches the
required parameter, wait for a
few seconds for it to change to
the value.
Enter the new value (see par. 8.1
to change numeric value). To
change a new parameter return
to point 4.
User manual ATR 900/901
or
. Press
Do
1234
. Press STEP
to skip
-
15
Publicité
Table des Matières
