Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
Programming and configuration
There are two programming levels:
1. Configuration (see chap. 9), to program main parameters (input type, measure
unit, P.I.D. parameters ext.);
2. Cycle programming, to define time-setpoint couples which creates cycle steps.
7.1
Entering or modifying a firing curve
The controller must be in STOP-mode and follows the points below.
Press
1
2
3
4
Display
Value on display changes
Displays the 1st segment of the
selected program. The number
of segments (1-9, A,B,C,D,E,F,) is
displayed on the 2nd display.
Press to scroll through and enter
time and temperature values
(and auxiliary relay if available) for
each segment
Increase or decrease
the displayed value.
Press
to scroll through the
parameters of selected cycle.
Press
to skip to the 1st
segment of the next program.
Press
to end programming
and press it again to start the
firing cycle
Do
Main display shows
the key to scroll through the
available programs and finally
the function "simple controller
tErM
, until the chosen program
is displayed
To program the delayed start of
firing cycle, enter the time value
(0:00-09:59) for step 0. Otherwise
skip to step no. 1
Enter the setpoint value (required
temperature). Led
Enter duration of segment
(hours:minutes). To set the maxi-
mum rise speed, press
JUNP
is displayed. Led
On. To finish the firing cycle, enter
End
(keep pressing
'END' is displayed). If auxiliary ou-
tput is enabled, select
Off
the relay or
to open it.
User manual ATR 900/901
ci c. 1
. Press
is On.
until
is
until
On
to close
-
11
Publicité
Table des Matières
