Twinkly Pro Connection Hub Guide D'instructions page 18

enabling the PoE
A TTIV A RE IL P OE | ACTIVATION DU S YSTÈME P OE |AKTIVIEREN DES POE | H ABIL ITACIÓN DE POE | INSCH AK EL EN
VAN DE POE | WŁĄCZENIE POE | У ВІМКНЕН НЯ ЖИ ВЛЕННЯ ЧЕРЕЗ ETHERNET | ВКЛЮЧЕН ИЕ P OE
1
2
CONNEXION RÉS EAU | NETZWERKVERBINDUNG-LED | L ED DE CONEXIÓN DE RED |
NETWERKV ERBINDINGS -LED | DIODA L ED POŁĄCZENIA SIECIOWEGO | СВІТЛОДІОД
EN
1. Power up the Power Line Controller connected to the PoE
IN port, then press and hold the button on the case until the
status LED makes a short red pulse.
– Once the PoE is turned on for the first time, it will remain
active even if you disconnect the controller.
– To turn off the PoE press and hold the button on the
controller until the flashing red LED stops.
2. Wait for connection to be established, refer to the network
connection LED on the Power Line Controller to make a burst
blink.
– In case you are using Twinkly PRO 4G Router, ensure you
have successfully configured it prior to this step, refer to its
quickguide for more info.
N ETWORK CO NNECTION LED | L ED CONNESS IONE DI R ETE | V OYANT DE
ПІД КЛЮЧЕН НЯ ДО МЕРЕЖІ | И НДИКАТОР СЕТЕВОГО ПОДКЛ ЮЧЕН ИЯ
STATUS LED | LED DI S TATO | VOY ANT D'ÉTAT | S TATUS-
L ED | L ED DE ESTADO | ST ATUS -LED | DIODA LED ST ANU |
СВІТЛОДІОД СТАТУСУ | И НДИКАТОР СОСТОЯН ИЯ
1
2