PowerVision PowerEgg X Guide De Démarrage Rapide page 3

If PowerEgg X and the waterproof case are not used as described above, the rubber seal strip may fail to work. In this
Warning
case, water may damage the aircraft and battery, which may cause explosion or fire. Water damage caused by
improper use is not included in the warranty.
• Install the waterproof case
1. Configure PowerEgg X to Drone mode.
2. Open the waterproof case and fit the tail of the aircraft into the waterproof case as shown.
Note: When fitting the tail of the aircraft into the waterproof case, make sure that the seal ring at the base of the arm is in full contact
with the rubber seal strip of the waterproof case, and that the seal ring is properly embedded in the groove of the rubber seal strip.
EN
2