Technical Data - GreenWorks G48ST8 STE302 Manuel Opérateur

EN
Problem Possible Cause
The ma- The guard is not
chine attached to the
stops machine.
when you
Heavy cutting
cut.
line is used.
The grass winds
around the motor
shaft or the trim-
mer head.
The motor is
overloaded.
The battery pack
or machine is too
hot.
The battery pack
is disconnected
from the tool.
The battery pack
is depleted.
The line Lines are welded
does not to themselves.
advance.
Not enough line
on spool.
Lines are worn
too short.
Lines are tan-
gled on spool.
English
Solution
Remove the battery
pack and attach the
guard to the machine.
Use only with the nylon
cutting line of 2 mm di-
ameter.
1. Stop the machine.
2. Remove the battery
pack.
3. Remove the grass
from the motor shaft
and trimmer head.
1. Remove the trimmer
head from the grass.
2. The motor will recov-
er to work as soon as
the load is removed.
3. When you cut, move
the trimmer head in
and out of the grass to
be cut and remove no
more than 8" in pass.
1. Cool the battery
pack until its function
returns to normal.
2. Cool the machine for
approximately 10 mi-
nutes.
Install the battery pack
again.
Charge the battery
pack.
Lubricate with silicone
spray.
Install more line.
Advance the cutting
line.
1. Remove the lines
from the spool.
2. Wind the lines.
Problem Possible Cause
The line The machine is
keeps used incorrectly.
breaking.
The grass Cut tall grass at
winds ground level.
around the
trimmer
head and
motor
housing.
The line The cut-off blade
does not becomes dull.
cut well.
Vibration The line is worn
increases down at one side
obviously. and not ad-
vanced in time.
8

TECHNICAL DATA

Voltage 48 V
No load speed 6500±10%/5600±10% RPM
Cutting head Bump feed
Cutting line diam- 2 mm
eter
Cutting path di- 279/330 mm
ameter
Weight (without 3.1 kg
battery pack)
Measured sound L
PA
pressure level
Guaranteed L
WA.d
sound power lev-
el
Vibration 6.81 m/s
Battery model G4824B2/G4824B4/G4824B6
Noise value.
8
Solution
1. Cut with the tip of
the line, avoid stones,
walls and other hard
objects.
2. Advance the cutting
line regularly to keep
full cutting width.
1. Cut tall grass from
the top down.
2. Remove no more
than 8" in each pass to
prevent wrapping.
Sharpen the cut-off
blade with a file or re-
place it.
Make sure that the line
on both sides is nor-
mal. Advance the line.
=<76 dB(A), K = 3 dB(A)
PA
= 96 dB(A)
2 2
, k=1.5 m/s