Troubleshooting; Technical Data; Warranty; Ec Declaration Of Conformity - GreenWorks G40PHA Manuel Opérateur

EN
7

TROUBLESHOOTING

Problem
The motor shuts
down whilst
working.
The machine
smokes during
operation.
The motor is on,
blades do not
move.
Too much noise
and/or vibration
is experienced
while working.
8

TECHNICAL DATA

Voltage
No load speed
Blade speed
Blade length
Possible cause Solution
Make sure that
The battery pack you tighlty instal-
is not installed led the battery
tightly. pack in the ma-
chine.
The battery pack Charge the bat-
is out of power. tery pack.
The machine Do not use the
has damage. machine and
speak to service
center.
1. Immediately
stop the ma-
chine.
The machine 2. Remove the
has damage. battery.
3. Speak to
service cen-
ter.
Do not use the
The machine machine and
has damage. speak to service
center.
Remove battery
The blades are then clear block-
blocked. age from the
blades.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are
3. Inspect for
loosen.
damage.
4. Check and
tighten loose
parts.
Do not use the
The parts have machine and
damage. speak to service
center.
40V
3000
(±10%) /min
3000
(±10%) /min
510 mm
English
Cutting capacity
Weight (without battery pack)
Measuered sound pressure level
Measuered sound power level
Guaranteed sound power level
Vibration
Uncertainty
9

WARRANTY

(The full warranty terms and conditions can be found on
Greenworks webpage)
The Greenworks warranty is 3 years on the product,
and 2 years on batteries (consumer/private usage) from
the date of purchase. This warranty covers
manufacturing faults. A faulty product under warranty
might be either repaired or replaced. A unit that has
been misused or used in other ways then described in
the owner's manual might be rejected for warranty.
Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not
affected by any additional warranty offered by a dealer
or retailer.
A faulty product must be returned to the point of
purchase in order to claim for warranty, together with
the proof of purchase (receipt).
10 EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name: GLOBGRO AB
Globe Group Europe
Address: Propellergatan 1, 211 15 Malmö, Sweden
Name and address of the person authorised to compile
the technical file:
Name: Peter Söderström
Address: Propellergatan 1, 211 15 Malmö, Sweden
Herewith we declare that the product
Category:
Model:
Serial number:
Year of Construc-
tion:
6
27 mm
3.5 kg
78 dB(A),
k=3.0
93.5 dB(A),
k=3.0
99 dB(A)
≤2.5 m/s
1.5 m/s
Pole Hedge Trimmer
PTF348
See product rating label
See product rating label
2
2