Krüger & Matz ODYSSEY Mode D'emploi page 25

Owner's manual
B - WALL MOUNTING
Note: Wall mounting must be carried out by qualified personnel only. Incorrect
assembly may result in severe personal injury and property damage. During
mounting, make sure the electric/plumbing installation will not get damaged when
drilling holes in walls! The supplied wall brackets are only for use on vertical walls
suitable for such mounting. It is the installer's responsibility to verify that the wall
will safely support the total load of the soundbar and wall brackets. Additional tools
required for the installation are not included. Do not overtighten screws.
1. drill 4 parallel holes (Ø 5,5-6 mm each according to wall type) in the wall. The
distance between the holes should be 1106 mm. Firmly fix 1 dowel into each
hole in the wall if necessary.
2. Tighten the wall mount brackets on the wall with screws and screwdriver (not
included). Make sure the they are securely installed.
3. Remove the screws at the back of the unit. Install the wall mounting screws into
the back of the unit.
4. Lift the unit onto the wall mount brackets and slot into place.
25