Battery Installation - Krüger & Matz ODYSSEY Mode D'emploi

BATTERY INSTALLATION

The unit has a pre-installed CR2025 battery. Remove the
protective tab to activate the remote control battery.
To replace the remote control battery:
1. Push the tab on the side of the battery tray towards
the tray.
2. Slide the tray out.
3. Retrieve used battery and insert new CR2025
battery with correct polarity (+/-) as indicated.
4. Slide in the tray to close the battery compartment.
Note:
• If you are not going to use the remote control for a
long time, remove the batteries.
• Batteries contain chemical substances, so they
should be disposed of properly.
• Caution: Risk of explosion! Keep batteries away
from heat, sunshine, or fire. Never discard batteries
in fire.
• The remote control sensor on the front unit is
sensitive to the remote control's commands up to a
maximum of 6 meters away and within a maximum
of a 30° angle.
• Please note that the operating distance may vary depending on the brightness
of the room.
• Any obstacles between remote control and the device or exposing it to direct
sunlight or other strong light as it will reduce operational range.
• Using this remote near other products which generate infrared rays may disturb
proper operation.
• dO NOT use other batteries than those specified.
MOUNTING
24
Owner's manual