Oven - Daily Use - Zanussi ZCG55DG Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Warning! Do not use abrasive cleaners, steel wool
pads or acids, they can cause damage to the
appliance.
• To clean the enamelled parts, cap and crown, wash it
with warm soapy water.
• Stainless steel parts wash with water, and then dry with
a soft cloth.
• The pan supports are not dishwasher proof; they must
be washed by hand.

Oven - Daily Use

Warning! Refer to "Safety information" chapter.
Oven function
Off position
Maximum gas supply
Pizza
Minimum gas supply
Gas oven cooking
Ignition of the oven gas burner:
1. Open the oven door.
2. Hold a flame near the hole in the bottom of the oven
cavity.
3. At the same time push the knob for the oven functions
down and turn it counter-clockwise to the maximum
setting.
• Make sure you position the pan supports correctly after
cleaning.
• To make burners work correctly, make sure that the
arms of the pan supports are in the centre of the burn-
er.
• Be very careful when you replace the pan supports to
prevent the hob top from damage.
After cleaning, dry the appliance with a soft cloth.
Oven Functions
The oven has these functions:
Application
To switch off the appliance.
To adjust the oven temperature - highest setting.
To make pizza.
To adjust the oven temperature - lowest setting.
4. When the flame comes on, keep the gas oven control
knob pushed for approximately 15 seconds.
After ignition:
1. Release the knob.
2. Close the oven door.
3. Turn the knob for the oven functions to the necessary
setting.
Oven safety device:
The oven has a thermocouple. It stops the gas flow, if the
flame goes out.
If the oven gas burner does not come on or if it ac-
cidentally goes out:
1. Release the knob for the oven functions and turn it to
the off position.
2. Open the oven door.
3. After one minute, try to light the burner again.
23

Publicité

Table des Matières
loading

Table des Matières