What To Do If - Zanussi ZCG55DG Notice D'utilisation

3
2
2
5
Use a spatula made of
wood or plastic or equiva-
lent to open the inner
door.
Hold the outer door, and
push the inner door
against the top edge of the
door.

What to do if...

Problem
The flame is blown out immediately
after ignition.
The gas ring burns unevenly.
The oven does not heat up.
The oven does not heat up.
Steam and condensation collect on
the food and in the oven.
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
28
6
Lift the inner door.
7
Clean inner side of the
door.
Clean the glass panel with
water and soap. Dry it
carefully.
Possible cause
The thermocouple is not heated suffi-
ciently.
The burner crown is blocked with
food residue.
The oven is not activated.
The necessary settings are not set.
You left the dish in the oven for too
long.
Warning! Only clean the glass panel with water and
a soap. Abrasive cleaning agents, stain removers
and sharp objects (e.g. knives or scrapers) can cause
damage to the glass.
Inserting the door and the glass panel
When the cleaning procedure is completed, insert the
oven door. To do so, do the steps in opposite way.
4
4
6
5
5
After lightning the flame, keep the
knob pushed for approximately 5
seconds.
Make sure that the injector is not
blocked and the burner crown is clear
of food particles.
Activate the appliance.
Control the settings.
Do not keep the dishes in the oven
for longer than 15-20 minutes after
the cooking ends.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
.........................................
.........................................
.........................................
Remedy