Adjustment - Fagor BB-300BF Mode D'emploi

6. ADJUSTMENT

1. Insert the two batteries in the battery
compartment (5) on the underside of the
scales.
2. If you only wish to know your weight,
press one of the upper corners of the
scale and select the weight unit (kg or
lb) using the Set button (3).
3. If you wish to use the scales in
calculation and analysis mode, follow
the instructions in point 7.
4. Place the scales on a hard, flat surface
(do not place them on a carpet). To
guarantee maximum accuracy and
repeatability of the readings, always
weigh yourself on the scales in the
same place.
7. FUNCTIONING
PROGRAMMING IN CALCULATION AND
ANALYSIS MODE
Personal data can be entered for each digit
(from 1 to 12), i.e. for up to 12 different
people. To programme the scales, proceed
as follows:
NOTE: first read the instructions, as the
display will switch off after 10 seconds if it
is not changed.
I. To switch on the scales, press "Set"
(3). When the number beside the icon
begins to flash, you can select the
desired memory setting (c) by moving
up and down with the
(2). Then press "Set" (3) to confirm the
data.
II. Then select the weight unit (f). To
change from one weight unit to another,
use the and buttons (2), and then
confirm with the Set button (3).
III. The next parameter to be entered is sex
IV. Another number will then begin to flash,
V. The last data item is age (e). Enter your
20
and buttons
To make sure all the parameters have
been correctly programmed, press
P01
"Set" (3) consecutively when you finish
programming.
14
kg
(a-b). When the symbol starts to flash,
use the and buttons (3) to select
male or female. Then press "Set" (4) to
confirm the data.
indicating the person's height (d). Use
the and (2) buttons to select the
height. Then press "Set" (3) to confirm
the data.
176
cm
age using the and
press "Set" (3) to confirm the data.
AGE
P01
25
AGE
buttons (2). Then
25
kg
176
cm