Changing The Remote Control Battery - Awox SLC-W13 Mode D'emploi

www.awoxstriim.com

Changing the remote control battery

1. Slide and lift off cover from back of remote control.
2. Use the tip of a pen to push back the tab in the corner.
3. Press bottom of battery to lift from slot.
4. To replace the battery, place the bottom of the battery
in first and push until it clicks into position.
If your Internet router supports WPS
WPS is a feature that enables you to add new WiFi devices to
your network at the touch of a button. If your Internet router
supports WPS, simply press the WPS button on the router and
then press the WPS button on your StriimLIGHT WiFi Color
device. The two devices will recognize each other automatically
and you may begin using the AwoX Striim CONTROL application
right away. Otherwise, the installation wizard runs as described in
the next section and will guide you through the WiFi
configuration.
Note: Do not use any kind of dimmer switch other than the
provided remote control unit.


AwoX StriimLIGHT WiFi Color – User Guide | 7

EN