Berbel AutoRun 2.0 Manuel De Montage page 50

Installation
3.4.4 Direct radio connection
This connection is only possible if the
extractor hood is equipped with a radio
module (e.g. ceiling lift hood Skyline).
 Observe the extractor hood
instructions.
☞ Ensure that the extractor hood is
installed and connected correctly.
A Additional button to switch the hob
lighting on/off
B Additional button to switch power
level 3 on/off
☞ Press the two additional buttons on
the extractor hood simultaneously
(> 3 sec.) to start the connection
process.
50
A
B
The connection starts automatically as
soon as the power supply is established.
The LED flashes for 2 minutes.
The "AutoRun® 2.0" device and extractor
hood are successfully connected by radio
if the LED lights up white for 10 seconds.
3.5 Perform check
The extractor hood starts automatically if
the heating stage on the hob is switched
on.
If the extractor hood does not switch on:
☞ Please consult your dealer or
customer services.
6005300_a – 17.03.2021