Berbel AutoRun 2.0 Manuel De Montage page 48

Installation
3.4.1 Radio connection via
"ConInterface"
This connection is required if further
accessories (e.g. remote control) are used
in radio operation and cable connection
is not possible (e.g. due to structural
conditions).
 Observe the "ConInterface"
instructions.
☞ Ensure that the extractor hood is
installed and connected correctly.
☞ Ensure that the extractor hood is
connected with the "ConInterface"
device.
☞ Perform the following steps for the
control panel supplied with your
extractor hood.
Extractor hoods with control panel "V8"
☞ Press and hold both buttons at the
same time (> 3 sec.) to start the
connection process.
Both buttons flash for 2 minutes.
48
Extractor hoods with control panel "V7"
☞ Press and hold both buttons at the
same time (> 3 sec.) to start the
connection process.
Both buttons flash for 2 minutes.
AutoRun® 2.0
The connection starts automatically as
soon as the power supply is established.
The LED flashes for 2 minutes.
The "AutoRun® 2.0" device and extractor
hood are successfully connected by radio
if the LED lights up white for 10 seconds.
6005300_a – 17.03.2021