Berbel AutoRun 2.0 Manuel De Montage page 49

Installation
If the connection process was not
successful:
☞ Press the button on the electronics
box.
Establishment of the connection starts
automatically for 2 minutes. The LED
flashes.
The connection process was successful if
the LED lights up white for 10 seconds.
3.4.2 Cable connection via
"ConInterface"
This connection is permissible if further
accessories (e.g. remote control) are used
in radio operation and cable connection
is not possible (e.g. with hob extractors).
The wall power supply is not required
and can be removed.
 Observe the "ConInterface"
instructions.
6005300_a – 17.03.2021
☞ Connect the device with the
"ConInterface" device on the extractor
hood.
The device is automatically detected by
the extractor hood.
3.4.3 Direct cable connection
This connection is permissible if no
further accessories (e.g. remote control)
are used in radio operation.
The wall power supply is not required
and can be removed.
☞ Connect the device with the extractor
hood via a connection cable (RJ45,
not included in the scope of delivery).
The device is automatically detected by
the extractor hood.
49