Berbel AutoRun 2.0 Manuel De Montage page 47

Installation
Automatic connection to the hob
The hob is connected but not switched
on.
The device automatically aligns itself with
the hob as soon as the power supply
is established. The LED flashes for max.
2 minutes.
The hob is connected when the LED
goes out.
Manual connection to the hob
If necessary (e.g. if faults arise during the
automatic alignment), the device can be
manually aligned with the hob.
The hob is connected but not switched
on.
☞ Press the button on the electronics
box for at least 5 seconds.
The LED flashes green.
The connection process was successful if
the LED lights up green for 5 seconds.
6005300_a – 17.03.2021
Factory settings
All existing connections are separated. All
settings are reset to factory settings.
The hob is connected but not switched
on.
☞ Press the button on the electronics
box for at least 10 seconds.
The LED lights up red briefly.
The device automatically aligns itself
with the hob. The LED flashes for max.
2 minutes.
The hob is connected when the LED
goes out.
3.4 Integrating the device in the
extractor hood system
The following options are available for
integrating the device in the extractor
hood system:
y Radio connection via "ConInterface".
y Cable connection via "ConInterface".
y Direct cable connection.
y Direct radio connection.
47