Adjusting The End Limits Of J4Wt Motors - SOMFY 5053520B Notice D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

12. Adjusting the end limits of J4WT motors

• Connect the Mod/Var Receiver RTS to the J4 WT motor.
• Switch on power supply
• After learning in the remote control push
It recognizes automatically if the motor is mechanical or electronical.
The learning in of the remote control is described in section 3 „Commissioning" or in the manual.
12.1 Commissioning the programming mode
• The screen must be positioned between the upper and lower end limit.
• Press both buttons
=> Motor turns briefly in Up direction.
12.1.1 Adjusting the upper end limit
• Press Up button
.
=> Motor turns, stops briefly, then continues in the Up direction.
The stop indicates the programming mode.
Press
after drapes have reached the desired upper end limit.
For fine adjustment of the upper end limit press
• Exit the programming mode without saving end position:
Push
button at the same time for 3 seconds.
• Exit the programming mode with saving end position:
Press Down button
=> Motor turns, stops briefly, then continues to turn in the Down direction.
The stop indicates that you have left the programming mode.
12.1.2 Adjusting the lower end limit
• Press the Down button
=> Motor turns, stops briefly, then continues to turn in the Down direction.
The stop indicates the programming mode.
Press
after drapes have reached the desired lower end limit.
For fine adjustment of the lower end limit press
• Exit the programming mode without saving end position:
Push
button at the same time for 3 seconds.
• Exit the programming mode with saving end position:
Press Up button
for storing the end limit and leaving the programming mode.
=> Motor turns, stops briefly, then continous to turn in the Up direction.
The stop indicates that you have left the programming mode.
Copyright © 2007-2010 Somfy SAS. All rights reserved.
5053520B Soliris ModVar Slim Receiver RTS_20100319 .indd 17
or
button.
simultaneously for at least 7 seconds.
and
for storing the end limit and leaving the programming mode.
.
and
buttons alternately.
buttons alternately.
17
09.04.10 14:16

Publicité

Table des Matières
loading

Table des Matières