Sun Disappearing - SOMFY 5053520B Notice D'installation

8.4 Clearing the "My" position
To clear the "My" position:
• Press the button on a RTS remote control that is paired (or temporarily
allocated if step 3.2 has not been applied): the blind lowers to the bottom
position, slats closed.
• Press the buttons
"My" position.
• Press the buttons
button will only operate as a "STOP" button).

9. Sun disappearing

9.1 Re-Setting the "sun disappearing" position
Note: It is not possible to re-set the "sun disappearing" position if the
"My" position has been cleared (step 8.4).
The "sun disappearing" position is pre-set at the factory but not activated, it
corresponds to the "slats raised" position.
To activate or modify this position (use a paired or temporarily allocated RTS
remote control if step 3.2 has not been applied):
• With the blind stopped, briefly press the
blind lowers, then the slats tilt to the "My" position.
• Press the buttons
"sun disappearing" position.
• Position the slats as required, using the scrollwheel of a paired or tempo-
rarily allocated RTS remote control to increase or decrease the slat angle.
9.2 Testing the "sun disappearing" setting
(optional step)
Press the button on a RTS remote control that is paired (or temporarily
allocated if step 3.2 has not been carried out):
• If the slats are in the "sun disappearing" position, the blind will go down
(if necessary) and the slats will tilt to the "My" position.
• If the slats are in the "My" position, they will tilt and the blind will go up
(if necessary) to the "sun disappearing" position.
9.3 Storing the "sun disappearing" position
In the "sun disappearing" position, press the
control that is paired for 5 seconds (or provisionally allocated if step 3.2
has not been carried out): the blind will confirm, the "sun disappearing"
position is stored.
9.4 Clearing the "sun disappearing" position
To clear the "sun disappearing" position, carry out the following procedure
(use a paired RTS remote control or one that is temporarily allocated if step
3.2 has not been carried out):
• Press the button: the blind goes down, then the slats tilt to the "My"
position.
• Press the buttons
"sun disappearing" position.
14
5053520B Soliris ModVar Slim Receiver RTS_20100319 .indd 14
for 2 seconds: the slats will tilt to the programmed
for 5 seconds: the "My" position is cleared (the
button for 0.5 seconds: the
for 2 seconds: the blind will go up to the
button of a RTS remote
for 2 seconds: the blind will go up to the
2 sec.
5 sec.
Telis Mod/Var Soliris
remote control
2 sec.
5 sec.
2 sec.
(C )
ONTINUED ON NEXT PAGE
Copyright © 2007-2010 Somfy SAS. All rights reserved.
09.04.10 14:16