Replacing The Rts Remote Controls (Emergency Procedure); My" Position - SOMFY 5053520B Notice D'installation

6. Replacing the RTS remote controls (emergency procedure)

This procedure can be carried out without losing the current settings, as well as the
RTS sensors already paired, in case of loss or deterioration of the RTS remote controls
already paired.
• Perform a double shutdown of the power supply (OFF 2 seconds – ON 5 seconds - OFF 2
seconds - ON): the blind goes down for 5 seconds, the Mod/Var receiver has cleared from
its memory the products already paired, except the RTS sensors, and is ready to pair a
new RTS remote control.
• Briefly press (0.5 seconds) the "PROG" button on the RTS remote control: the blinds will
confirm, the new RTS remote control is paired.
7. Returning to factory settings
This procedure clears all the settings made previously to return to the factory
configuration.
• Carry out a double switch off of the power supply
(OFF 2 seconds - ON 5 seconds - OFF 2 seconds - ON): the blinds go down for 5 seconds,
the Mod/Var receiver has cleared the products already paired from its memory.
• Press the "PROG" button on a RTS remote control for 7 seconds: after 2 seconds, the
blind perform an initial confirmation, then after another 7 seconds the specific settings
are cleared.

8. "My" position

8.1 Re-setting the "My" position
The "My" position is pre-set in the factory, it corresponds to the "slats lowered,
sun protection" position. To modify this position (use a paired or temporarily
allocated RTS remote control if step 3.2 has not been applied):
• Press the button: the blind lowers to the bottom position, slats closed.
• Press the buttons
programmed "My" position.
• Position the slats as required, using the scrollwheel of the RTS remote control
to increase or decrease the slat angle.
8.2 Testing the "My" position (optional step)
Press the button:
• If the slats are in the "My" position, they will tilt to the closed position.
• If the slats are in the closed position, they will tilt to the "My" position.
8.3 Storing the "My" position
In the "My" position, press the
the "My" position is stored.
Copyright © 2007-2010 Somfy SAS. All rights reserved.
5053520B Soliris ModVar Slim Receiver RTS_20100319 .indd 13
for 2 seconds: the slats will tilt to the
button for 5 seconds: the blinds will confirm,
2 sec. 5 sec. 2 sec.
«prog»
0,5 sec.
NEW
2 sec. 5 sec. 2 sec.
«prog»
0 .. 2 sec .... 7 sec.
7 sec.
NEW
2 sec.
5 sec.
09.04.10 14:16
NEW
5 sec.
5 sec.
13