Witter C46A Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar with European facing to 94/20/EC A50-1
B 2 Side Arms
C 4 M10 x 1.5 Cage Nuts (small)
D 2 Side brackets
E 3 M10 X 35 X 1.5 Pitch Bolts, lock washers and flat Washers (25mm OD)
F 1 M10 X 30 X 1.5 Pitch Bolts, lock washers and flat Washers (25mm OD)
G 2 M12 X 40 X 1.75 Pitch Bolts, lock washers, flat washers (25mm OD) and 2 nuts.
H 2 M10 X 35 X1.5 Pitch Bolts, lock washer, flat washer (25mm)
J 4 M12 X 40 X 1.75 Pitch Bolts, lock washers, flat washers (25mm OD) and 4 nuts
CB 2 M16 X 50mm X 2.00 Pitch Bolts, Lock washers, 2 nuts
K 1 ZEP35 Electrical plate (not shown)
L 1 Witter Tow ball cover
FITTING
Check to ensure that you have all the necessary parts.
1.
2. From underside of vehicle unscrew bumper tags and remove lower underside arch plugs, 2 each side.
On outside of chassis rails remove tape to expose chassis mounting points. Remove any wax oil as necessary.
3.
Insert M10 cage nuts (C) into the chassis rail ensuring that the cage nut hole recess aligns as per diagram 2.
4.
Fit Side arm (B) to outer chassis rails using fasteners (E & F) and tighten fully. (F) being shorter due to fuel pipe
5.
obstacle.
Expose the rear most captive mounting hole by removing the tape on the underside of the chassis rails. Attach brackets
6.
(D) to the underside chassis rail using bolts (H) via captive thread and bolts (G).
To fit cross bar (A), lower rear silencer by undoing rear and front hangers. On rear panel bend upwards rearmost
7.
bumper tags . Slide crossbar over exhaust and insert crossbar carefully flexing bumper rearward if required.
Tighten fixing (J) to side arms whilst holding cross bar in its highest position.
8.
Should more space be required between centre profiles and rear floor pan loosen bolts (J) and adjust accordingly.
9.
Tighten all remaining bolts to their recommended torque.
10.
Bend bumper tags down and refit screws and plugs
11.
This towbar must be used with either a Witter tow ball (part number Z11) or Class A50-1 or A50-X tow ball dimensionally.
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Recommended torque settings: M10 - 52 Nm, M12 - 80 Nm, M16 - 200 Nm
Diagram 1
Diagram 2
W0001C46A-FIT$010904220000TÄ
W 0001C46A-FIT$010904220000
TOWBAR
For Citroen C3 Picasso
2009 -
C46A