Télécharger Imprimer la page

Reiner K1 Mode D'emploi page 5

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
GB
To set the stamp wheels
Press the handle
travel, then while still holding it.
Press bolt
at the bottom end of the handle.
Guide the handle
snaps into a depression.
You will be able to move the stamp wheels
freely with the stylus
You can lower the preceding zeros!
Example:
49
Turn the stamp wheel
digit position "0".
Using stylus
rotate and push down on
stamp wheel
through a half digit position
until it sinks below print height.
To return to the print position, simply push
bolt
in the middle of the handle
Any wheel which has been 'sunk' will auto-
matically be brought to print height as the
numbering sequence progresses. 'Sunk' wheels
can be brought into play by simply rotating
them further (ie. push towards figure 1.).
To insert the inkpad
Note: Use only oil-containing stamp ink.
Handle with caution to avoid dirt from ink!
Press the handle
travel, then, while still holding it.
Press the button
continue to hold it.
1
2
Fig.
+
to the bottom of its
upwards until the handle
.
instead of
000049
with stylus
to
.
1
3
Fig.
+
to the bottom of its
on the front plate and
Allow the handle
handle locks in place.
Unpack the inkpad carefully.
Insert the inkpad in the slot
up to the limit stop and fasten with the
screws of the inkpad.
Resting the back of the ink pad inside the pad
cradle slide the pad into the slot
In order to return to the starting position,
hold handle
and push bolt
To change the numbering actions
Actions
0
The same number is stamped every time.
1
Number increases after each stamping
process.
2
Number increases after every 2
stamping process.
etc.
Loosen the screw
Raise the automatic
at the desired interval.
Tighten the screw
To park the stamp
To prolong the life of the inkpad, park the stamp!
Press the bolt
at the bottom end of the
handle and then keep pressing it.
Gently push handle
stamp clicks & locks in a raised position.
To return to the starting position, hold
handle
and push bolt
GB
to move upwards until the
of the stamp
of the stamp.
in the middle.
Fig.
nd
.
and place the slide
.
5
Fig.
downwards until the
in the middle.
4

Publicité

loading