Measuring Functions - Bosch GLM400C Consignes D'utilisation Et De Sécurité

Note: Integrated Help Function
Help in the form of an animation is stored in the measuring tool
for each measuring function. To do so, select button 13 [Func],
buttons 4 [+] or 11 [–] and then soft key 3 [
The animation shows you the detailed procedure for the selected
measuring function. The animation can be stopped and started
again at any time. You can scroll forward and back with buttons
4 [+] or 11 [–].
Length Measurement
Select the length measurement
To switch on the laser beam, briefly press the measuring button
2 [ ].
09.06.2017
13:20:23
0.0º
76´01˝ ⁄
measured value is above it, and so on.
Continuous Measurement (Tracking)
For continuous measurements, the measuring tool can be moved
relative to the target, whereby the measuring value is updated
approx. every 0.5 seconds. In this manner, as an example, you
can move a certain distance away from a wall, while the actual
distance can always be read.
Select the continuous measurement
To switch on the laser beam, briefly press the measuring button
2 [ ].
Move the measuring tool until the required distance value is
indicated in the bottom of the display.
09.06.2017
13:20:23
0.0º
min
max
76´01˝ ⁄
Continuous measurement automatically switches off after 5 mins.
2610049010 04-18 GLM400C.indd 27

Measuring Functions

To measure, briefly press the measuring button 2 [ ].
The measured value will be shown at the bottom of
30´05˝
the display.
45´08˝
60´10˝⅝ Repeat the above-mentioned steps for each
subsequent measurement. The last measured value
is at the bottom of the display, the penultimate
Briefly pressing the measuring button 2 [ ] interrupts
the continuous measurement. The current measured
30´05˝
value will be shown at the bottom of the display. The
76´01˝ ⁄
maximum and minimum measured value appear
above it. Pressing the measuring button 2 [ ] once
more restarts the continuous measurement.
].
.
.
27
4/6/18 8:20 AM