Settings Menu - Bosch GLM400C Consignes D'utilisation Et De Sécurité

Permanent Laser Beam
If necessary, you can switch the measuring tool to permanent
laser beam operation. To do so, use soft key 3 [
the basic settings for the measuring tool. Use buttons 4 [+] or
11 [–] to select the permanent laser beam and confirm this by
pressing button 13 [Func].
Do not point the laser beam at persons or animals and
do not look into the laser beam yourself, not even from a
large distance.
In this setting, the laser beam remains switched on even
between measurements; measurement simply requires one
brief press of the measuring button 2 [ ].
The permanent laser beam can be switched off again in the
basic settings or automatically when the measuring tool is
switched off.
To enter the "settings" menu (i) briefly press soft key 3 [
press and hold button 13 [Func].
Use button 4 [+] or 11 [–] to select the relevant basic setting
and press button 13 [Func] to select the required setting.
To exit the "settings" menu, press the On/Off button 9 [ ] or
soft key 12 [
2610049010 04-18 GLM400C.indd 23
"Settings" Menu
].
Settings
Bluetooth
Reference Level
Meas Timer
Permanent Laser
Tilt Calibration
CAL CAL
CAL
CAL
Viewfinder Calibration
CAL
CAL
CAL
Memory
Tool Settings
®
] to select
] or
23
4/6/18 8:20 AM