Replacing The Lamp - AEG DCK0250HG Notice D'utilisation

36 www.aeg.com
The dishwasher must be set
to a low temperature and a
short cycle. The grease filter
may discolour, it has no
influence on the
performance of the
appliance.
5. To mount the filters back follow the
first two steps in reverse order.
Repeat the steps for all filters if
applicable.
4.3 Cleaning the charcoal
filter
To remove the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in
this chapter.
2. Remove the clips holding the filter
bed (1), then the filter bed (2).
2
5. GUARANTEE
CH
Customer Service Centres
1
Industriestrasse 10
5506 Mägenwil
3. Wash the filter bed in hot water
without using detergent or use a
dishwasher.
Set the dishwasher without
using rinse aids or any other
detergents. The dishwasher
cannot be filled with dishes.
4. Leave the filter bed to dry or use an
oven.
Set the oven for 7 minutes in
the maximum temperature of
60°C.
5. To install the filter, perform the steps
in reverse order. The filter has to be
fully dried before installing it back into
appliance.
Replace the filter bed every 2 years or
when the cloth is damaged.

4.4 Replacing the lamp

This appliance is supplied with a LED
lamp. This part can be replaced by a
technician only. In case of any
malfunction refer to "Service" in the
"Safety Instructions" chapter.
Point of Service
Le Trési 6
1028 Préverenges
Via Violino 11
6928 Manno