Automatic Shooting; About Installation - Sony IPT-DS1 Manuel D'utilisation

Automatic shooting

1 Set the ON/OFF (power) switch of this unit to ON.
The tilt arm moves to the initial position and this unit enters standby mode.
¦
Notes
Set the ON/OFF (power) switch to OFF when you want to stop operation
immediately or do not intend to use this unit for a long time.
¼
Tips
This unit automatically enters standby mode if automatic shooting is not
performed. You can leave the ON/OFF (power) switch of this unit to ON for
regular use.
2 Set the power switch of your camera to ON.
The camera enters shooting mode.
For details, refer to the operating instructions of your camera.
3 Attach your camera to this unit (page 18).
This unit starts automatic shooting. For details, see page 22.
Status of this unit
ON/OFF
(power) switch
of this unit
ON
*1 Indicator B lights up in red when an AC adaptor is connected to this unit.
*2 When the MENU button is pressed, this unit enters MENU mode.
When the ON/OFF (power) switch of this unit is set to OFF, it does not turn on
ˎ
even when you attach your camera to this unit.

About installation

Use this unit where:
it is stable and flat.
ˎ
the camera has a clear view of people's faces.
ˎ
there are no objects nearby that may fall over.
ˎ
20-GB
Camera
Not attached
Attached
Power switch of
your camera

OFF
ON
Status of this unit
Standby*1
Automatic
shooting*2