Thetford CASSETTE C-200 CW D3 Instructions Pour L'installation page 3

Thetford C-200 CW Cassette
General information
C-200 CW Cassette aftermarket
specification
The valve blade is operated manually using a handle.
The toilet has an integrated water tank and is flushed
with a hand pump.
Important: We recommend thet you have the Thetford
Cassette toilet installed by a dealer.
The Thetford C-200 Cassette is a semi-portable toilet
for caravans and campers which is integrated in the
bathroom. We recommend that the welding seam
around the base of the toilet is used to trap the shower
tray. The shower tray with upstanding surround can be
connected below this welding seam to prevent leaks
when the shower is used. The C-200 Cassette can also
be installed in a caravan without a shower tray.
Installation details
1. The bathroom must be a minimum of 500 mm wide
and the floor must be at least 500 mm deep,
calculated from the rear wall. To allow for the toilet
seat, the clearance height must be 822 mm. At the
back there is an opening at floor level for a (Ø 65 mm
heating cable, three (Ø 16 mm water supply lines and
two (Ø 8 mm electric leads. We recommend that the
air duct (plenum) is used to lead trough the heating
cable. (See drawing 2)
2. If the toilet is near the wheel housing, the distance
between the housing trim and the hole to be made
must be at least 20 mm. If the toilet is at the back of
the caravan, the distance between the hole to be
made and the caravan's rear wall must also be
20 mm. (See drawing 5 + 6)
3. The toilet must be mounted against a vertical rear
wall. The rear wall must be at least 728 mm high.
4. The wall thickness of the caravan or camper must be
between 24 and 46 mm. When the caravan wall is
thicker then 40 mm, the O-ring of the waterfill door
has to be replaced (contact Thetford). A wooden
frame or a frame of 3 mm aluminium strips must be
placed round the large doorway so that the door
can be securely attached. The frame is glued to
the wall around the large doorway for additional
strength. (See drawing 12)
5. Thetford recommends that the large door should
hinge in the direction of travel.
6. Consult your caravan dealer in respect of the cut-out
in the caravan wall, in order to prevent any damage
Useful tips
- To facilitate installation, drawings have been enclosed
to make templates.
- The installation instructions must be followed
precisely.
- Tools required:
* an electric drill
* 3 and 8 mm bits
* an electric saw
* a screwdriver with Philips head nr. 2
* an awl
* safety glasses
* a marker
* butyl sealant
The cut-out from the caravan wall for the large door
is used as the door panel; only saw or drill in the
places indicated in the instructions.