Sony WEGA KLV-30MR1 Mode D'emploi page 29

Contrast
Brightness
Colour
Colour cannot be adjusted for an RGB input signal connected to the PC
Hue
Hue can only be adjusted for NTSC colour signal (e.g. USA video tapes).
Sharpness
This function does not operate in PC mode and in Memory Stick.
Back Light
When Power Saving mode is set to on, if you change the Back Light, only the bar of the
Back Light moves. The brightness of the Back Light does not change.
NR (Noise Reduction) Auto/Off/Low/Middle/High
NR (Noise Reduction) cannot be adjusted for an RGB input signal connected to the PC
connector, a DTV* signal connected to the Y, P
"Memory Stick" input.
* DTV is the digital broadcast format in the United States (e.g. digital tuner with RGB
signal).
Dynamic Picture
Colour Tone
Colour Correction
Colour Correction cannot be adjusted for an RGB input signal connected to the PC
connector.
Gamma Correction High/Middle/Low
Reset
• No option can be adjusted when Mode is set to Live.
• Only Contrast can be adjusted when Mode is set to Standard or Movie.
Press or to reduce picture contrast.
Press or to enhance picture contrast.
Press or to darken the picture.
Press or to brighten the picture.
Press or to decrease colour intensity.
Press or to increase colour intensity.
Press or to decrease the green tones.
Press or to increase the green tones.
Press or to soften the picture.
Press or to sharpen the picture.
Press or to darken the Back Light.
Press or to brighten the Back Light.
Select to reduce the noise level.
On/Off
Select to enhance the picture contrast.
Cool/Normal/Warm
Select to give bright colours a red tint (Setting is variable from Cool to
Warm).
On/Off
Select to emphasise reds and blues.
Select to adjust the balance between bright and dark areas of the picture.
Cancel/OK
Select OK to reset the picture to the factory preset levels.
/C , P /C jacks of
B B R R
Menu System
connector.
5, and the
GB
27