Recording A Cd By Specifying Tape Length (Time Edit/Just Edit) - Sony CDP-XB930 Mode D'emploi

Recording From CDs
When tracks, which aren't numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
Recording a CD by Specifying
Tape Length
(Time Edit/Just Edit)
You can have the player create a programme that will
fit the length of the tape. Select one of the following
options:
• Time Edit: automatically creates a programme,
keeping the original order of the disc. However,
when the remaining time becomes shorter than the
next succeeding track, the player automatically
programmes a track which is nearly equal to the
remaining time.
• Just Edit: automatically arranges the track order to fit
the tape length.
The programme may contain up to 24 tracks (a pause
inserted between tracks is counted as one track).
Note that tracks numbered over 24 cannot be
programmed in this feature.
1
Press EDIT/TIME FADE before you start playing
as follows:
• To select Time Edit, press the button until
"EDIT" appears and "A" of "TAPE A" flashes in
the display.
• To select Just Edit, press the button until
"JUST EDIT" appears and "A" of "TAPE A"
flashes in the display.
2
Press 0 or ) to specify the tape length.
Each time you press these buttons, the display
changes as shown below with the tape length of
one side .
n HALF ˜ C-46 23.00 ˜ C-54 27.00 ˜ C-60 30.00 N
n - -. - - ˜ C-90 45.00 ˜ C-74 37.00 N
GB
16
EDIT/TIME FADE
0/) ·
P
When you select "HALF"
The player divides the total playing time of the disc in
half, keeping the original order (only in Time Edit).
Note that you cannot select "HALF" when the disc has
more than 24 tracks.
3
Press EDIT/TIME FADE to have the player create
the programme.
The music calendar shows the tracks to be
recorded. "B" of "TAPE B" flashes in the display.
4
When you record on both sides of the tape, press
EDIT/TIME FADE again.
The player inserts a pause, then creates the
programme for side B. The display shows the
programmed tracks.
When you record on one side of the tape or on a
DAT or MD, skip this step.
5
Start recording on the deck and then press · on
the player.
When you record on both sides of the tape, the
player pauses at the end of the programme for side
A.
6
When you record on side B, reverse the tape and
press · or P on the player to resume playing.
To cancel Time Edit/Just Edit
Press PLAY MODE.
When using the remote, press CONTINUE.
You can specify the tape length freely in Step 2
You can set the tape length using ≠ AMS ±.
Example: When the tape length of one side is 30 minutes
and 15 seconds
1 To set the minutes, turn ≠ AMS ± until
"30" appears in the display, then push
≠ AMS ±.
2 To set the seconds, turn ≠ AMS ± until
"15" appears in the display, then push
≠ AMS ±.
When tracks, which aren't numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
To check and change your programme
See page 15.