Unpacking; Hooking Up The System - Sony CDP-XE500 Mode D'emploi

Getting Started
Getting Started Getting Started

Unpacking

Check that you received the following items:
• Audio connecting cord (1)
• Remote commander (remote) (except for
CDP-XE200) (1)
• Sony SUM-3 (NS) batteries (except for CDP-XE200) (2)
Inserting batteries into the remote
(except for CDP-XE200)
You can control the player using the supplied remote.
Insert two size AA (R6) batteries by matching the +
and – on the batteries. When using the remote, point it
at the remote sensor g on the player.
When to replace batteries
With normal use, the batteries should last for about six
months. When the remote no longer operates the player,
replace all the batteries with new ones.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you don't use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
4
EN

Hooking Up the System

Overview
This section describes how to hook up the CD player to
an amplifier. Be sure to turn off the power of each
component before making the connections.
LINE OUT
LINE OUT
(R) (L)
Audio input Audio input
(L)
: Signal flow
What cords will I need?
Audio cord (supplied) (1)
White
(L)
Red
(R)
Hookups
When connecting an audio cord, be sure to match the
color-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player
CD player
To an AC outlet
(R) Amplifier
To an AC outlet
White
(L)
Red
(R)
Amplifier