Orderman Max2 Mode D'emploi page 16

User Manual
The following settings can be chosen in the Orderman setup.
Touch calibration set-up
Touch calib.
First, touch the four crosses on the display using the Orderman
touch pen. Followed by the four points on the menu card (the
sequence will be shown in the display).
Setting the contrast and background lighting
Display
Using the Orderman touch pen, pull the bar in the bar area to
change the contrast ("contrast") and the brightness of the
display ("backlight").
Setting the automatic switch off times
Time out
In the "Power Off" bar field, the switch off time (seconds) can
be set by pulling the bar, after which the device will switch off
automatically, if it is not operated. In the "Back-Light" bar field,
pull the bar to set the time (seconds) after which the back light-
ing (display and menu card area) will switch off, if the device is
not operated.
Test of the equipment's basic functions
Hw Test
In this menu you can test your equipment's basic functions i.e.
Bluetooth interface and the touch's function. You can test all op-
tions existing in the equipment (Orderman Card Swipe,
Orderman Legic and ISO Transponder Reader as well as the
Orderman Order Card) too.
Software - Versions
Versions
In this menu, the software versions and the name of the menu
card (BLY) are shown.
Max2
- 16 -
Handset