SWITCH OPERATION
The TLR-7
and TLR-8
®
TLR-8
A models feature ambidextrous rear switches. All models provide momentary or
®
constant activation and allows selection of the light/laser (TLR-8
• A tap on either switch turns the unit "on" or "off".
• Press and hold either switch for momentary activation of the unit.
• To cycle through the available modes (TLR-8
press and hold one switch and tap the other switch until desired mode is reached.
The selected mode will be saved when unit is turned "off".
• NOTE: The TLR will not operate if the facecap is in "safe" mode.
Laser Adjustments
TLR-7
A and TLR-8
®
The TLR-7
A and TLR-8
®
preference. The LO tail switch presents the rear switch lower on either side of the trigger guard
while the HI tail switch presents the rear switch higher up on either side of the trigger guard.
The LO and HI tail switches are interchangeable by removing the tail screws using a 5/64"
hex wrench. Ensure both actuators are in place on the tail switch before installation
(see Tail Switch Actuator view below).
NOTE: The LO and HI tail switches are not compatible with the TLR-7
side switch models.
TLR-8
A HI tail switch
®
Strobe Enable/Disable
The TLR-7
and TLR-8
®
strobe, starting from the "Off" position, tap either switch very rapidly 9 times (within ¼
second per tap) and hold down on the 10th time. Hold the switch until the light turns off
(about one second) which indicates reprogramming was successful. Repeat the procedure
above to disable strobe mode.
Strobe Operation
The TLR-7
and TLR-8
®
Within ¼ second, press either switch, release and immediately re-press for strobe.
models feature ambidextrous side switches. The TLR-7
®
A Models Rear Switch Options
®
A have two versions of tail switch available, depending on user grip
®
ship from the factory with the strobe mode disabled. To enable
®
strobe mode can be activated by either switch.
®
models only; Light, Laser, Light/Laser),
®
Switches
Tail
Switch
Actuator
Switches
®
models only).
®
and TLR-8
®
TLR-7
A LO tail switch
®
A and
®