Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(1) Switching to "hammering"
(a) Push the button, release lock and turn the
selector lever counterclockwise.
(b) Align ▲ of the selector lever and
lever holder as illustrated in Fig. 7.
(c) Release the button to lock the selector lever.
NOTE:
Turn the selector lever (do not push the button)
to check if it is completely locked and make sure
that it does not turn.
(2) When fixing working positions of tools such as
cold chisel, etc.,
(a) Push the button, release lock and turn the
selector lever.
Align ▲ of the selector lever and
lever holder as illustrated in Fig. 8.
(b) Release the button to lock the selector lever.
(c) Turn the grip as illustrated in Fig. 9 and fix
the tool to the desired working direction.
(d) Switch the selector lever to "hammering"
according to the procedures mentioned in
the above item (1) and secure the position
of the tool.
5. Install the stopper (Fig. 10)
(1) Loosen the side handle and insert the straight
portion of the stopper into the handle bolt hole
from the front cover.
(2) Loosen the side handle, move the stopper to
the specified position and rotate the grip of the
side handle clockwise to fix the stopper.
Lever Holder
of the
Button
Lever Holder
of the
Selector Lever
Stopper
English
Selector Lever
Fig. 7
Button
Fig. 8
Grip
Fig. 9
Side Handle
Fig. 10
13
Publicité
Table des Matières
