Filter Removal; Important - Kenmore ULTRACLEAN 665.1456 Série Guide D'utilisation Et D'entretien

Filter Removal

1. Turn the upper filter assembly a ¼ turn counterclockwise and lift out.
2. Grasp the lower filter in the circular opening, lift slightly, and pull forward
to remove.
3. Clean the filters as shown below.
Cleaning
IMPORTANT: Do not use wire brush, scouring pad, etc., as they
may damage the filters.
Rinse filter under running water until most soils are removed.
If you have hard-to-remove soils or calcium deposits from
hard water, a soft brush may be required.
Filter Reinstallation
1. Noting the previous illustrations, place the lower filter under the locating tabs in
the bottom of the dishwasher, so the round opening for the upper filter assembly
lines up with the round opening in the bottom of the tub.
2. Insert the upper filter assembly into the circular opening in the lower filter.
3. Slowly rotate the filter clockwise until it drops into place. Continue to rotate until
the filter is locked into place. If the filter is not fully seated (still turns freely),
continue to turn the filter clockwise until it drops and locks into place.
NOTE: The upper filter assembly arrow does not have to align with the arrow in
the lower filter as long as the filter is locked.
IMPORTANT: To avoid damage to dishwasher, do not operate your dishwasher without the Ultra Wash
Be sure the lower filter is securely in place and the upper filter assembly is locked into place. If the upper filter assembly turns
freely, it is not locked into place.
Locating tab
To remove upper filter assembly
Locating tab
To replace upper filter assembly
filters properly installed.
®
9