Soil Settler Soil Removal System; Start-Up Guide; Using Your New Dishwasher - Kenmore 665.17432 Guide D'utilisation

Soil Settler Soil Removal System

The Soil Settler soil removal system cleans by spraying a mixture
of hot, clean water and detergent against soiled dishes.
When a cycle is started, the dishwasher fills with water to a level
near the bottom of the overfill protector. This water is pumped
through the rotating spray tower and spray arm, circulated
through the filter system which collects food and soil, and
pumped back through the rotating spray tower and spray arm.
Soiled water is then pumped out and replaced with clean water
during a cycle; the number of times depends on the cycle being
used.
To clean the Soil Settler filter screen
1. Wait at least 20 minutes after a cycle for the heating element
to cool down.
2. Unload and slide the bottom rack forward. (Remove bottom
rack if necessary to reach filter screen.)
3. Remove collected particles from the screen with your finger
or a paper towel.
4. Return the bottom rack to its original position.

START-UP GUIDE

Before using your dishwasher, remove all packaging materials.
Read this entire Use and Care Guide. You will find important
safety information and useful operating tips.

Using Your New Dishwasher

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
A power supply of 120 volts, 60 Hz AC, 15 or 20 amps, is
required.
1. Plug into a grounded 3 prong outlet.
2. Scrape large food soil and hard items (toothpicks or bones)
from dishes.
3. Properly load the dishwasher. (See "Dishwasher Loading.")
Make sure nothing prevents the spray arm(s) from spinning
freely.
4. Add detergent and check the rinse aid dispenser. Add rinse
aid if needed. (See "Dishwasher Use.")
7